If there are problems during operation of the powder milling machine, press the emergency stop (all the parts of the machine will be stopped).
|
Faults |
Reason |
Shooting |
|
The motor doesn’t work |
1. fuse breaks off 2. contactor doesn’t contact well 3. the circuit is not through |
1. change the fuse 2. check or change it 3. check or change the wiring |
|
Noise |
1. bearing is attrited 2. unbalance of main shaft, movable hammer, fan device |
1. change the bearing 2. do the balance test |
|
Low capacity, uneven powder |
1. movable hammer or liner is attrited 2. tube jam; powder stick on the impeller of the air-lock device 3. filer pockets are broken 4. air leak of the tube 5. sieve is broken or has the jam |
1. change them 2. clean the tube and the air-lock device 3. adjust or change it 4. seal it 5. clean or change it |
January 25, 2024
January 15, 2024
February 19, 2024
January 14, 2024
January 25, 2024
January 14, 2024
Wyślij je do tym dostawcy
January 25, 2024
January 15, 2024
February 19, 2024
January 14, 2024
January 25, 2024
January 14, 2024
Wyślij zapytanie
Ms. Susan
Tel:86-0510-86184255
Fax:
Mobile Phone:+8615961650796
Email:277319138@qq.com
Adres:No.8 Dongmeng Road, Dongmeng Technology Zone, Nanzha Town, Jiangyin , Wuxi, Jiangsu
Strona mobilna
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
